Tips And Techniques For Laser Engraving And Cutting

The laser sometimes with is certainly an Epilog Helix as well as the program we use to function its Corel Draw. I will try to write generally to be able to visit whichever laser and program you have to.

Note: For several these pointers you need to know the among Vector files and Bitmap files. Vector files are mathematical formulas defining lines, circles etc. They’re created by programs like Adobe Illustrator, Inkscape, AutoCAD and Corel. Bitmap files are collections of human pixels. This incorporated digital photos, Adobe Illustrator files, JPGs etc. While using Epilog laser (and I’m presuming others) you’ll be able to only cut getting a vector file. You’ll be able to engrave with either vector or bitmap files. For a lot of of my methods you will need your file to become vector applies for that secret to function.

Prior to to techniques for cutting and engraving, we start having a couple of plans for about to cut or engrave.

Masking: In situation your prone to engrave on something keep in mind that the smoke for your engraving can stain the sides in the incisioni su legno. If you don’t want that go over the very best with masking tape to guard it. The masking tape won’t decrease the effectiveness of the laser much (raise the ability just a little if you feel it takes it) as well as the masking tape will safeguard the material across the engraving within the smoke. After running the engraving just peals the masking tape off. I take advantage of vid lot should i be engraving on leather.

Presets: Your laser should have some suggested settings for cutting or engraving various materials as well as other thicknesses. It’s also advisable to be capable of load these settings for your computer or laser and save them as presets. Make certain to mention them a thing that is smart to be able to find them By doing this the next time you need to engrave on leather or cut 1/8″ thick acrylic, it is simple to uncover the preset for the material.

Test cuts: Even when I have had a preset for cutting a cloth I make an effort to manage a test loss of it before I run the whole job. Nothing’s more uncomfortable than while using material in the laser and finding that it didn’t cut completely through. I create a small circle or square (about 1/4″ or 1/2″ wide) and eliminate in corner or on some scrap material. Then I will tell if I must decrease or boost the ability before I run the best cut.

A few of the methods I will talk about require getting the opportunity to print only part of data or design at any time. The easiest method to have this tried it to put various parts of you design on several layers in the file. Most graphics programs let you create different layers then to exhibit them on and off. While place everything on one layer listed here are a couple of advantages of choosing layers.

Previous Article
Next Article

Leave a Reply

Your email address will not be published. Required fields are marked *